Thursday, July 18, 2019

Trestolone Acetate

Trestolone Acetate

Product name: Trestolone Acetate

CAS No.: 6157-87-5

Synonyms:17β-Hydroxy-7α-methylestr-4-en-3-one acetate; 3-Oxo-7α-methylestra-4-ene-17β-ol acetate;

Acetic acid 3-oxo-7α-methylestra-4-ene-17β-yl ester;

NSC-69948; U-15614

Molecular Formula:C21H30O3

Melting Point: 447.571 °C at 760 mmHg

Molecular Weight: 330.47

Flash Point: 194.228 °

Density: 1.117 g/cm3

Appearance: White powder

Usage: Pharmaceutical raw materials, bodybuilding and sex enhancement ,Androgen Replacement Therapy

Web: www.rawsgear.com

Web: www.rawsgearpharma.com

Email: [gear@quality-steroid.com](mailto:gear@quality-steroid.com)

Skype: +8615711952876

Whatsapp +8615711952876

Trestolone Acetate Description:

Chemically speaking, trestolone acetate(MENT) actually an alright looking drug. It doesn't show much interaction with Sex Hormone Binding Globulin, which means that a good portion ought to stay unbound and active in the blood. Also, the drug is a potent binder to the androgen receptor, while showing minimal affinity for the progesterone and mineralocorticoid receptors respectively. Since it is not able to be 5a reduced into a dihydroversion, it likely wouldn't cause many of the side effects commonly associated with Dihydrotestosterone. This is also a likely reason that it is less apt to cause prostate enlargement, and may even be indicated for the treatment of specific prostate issues.

The ability of 7 alpha-methyl-19-nortestosterone acetate (MENT) to increase the weights of ventral prostate and seminal vesicles of castrated rats was four times higher than that of testosterone, while its effect on the weights of bulbocavernosus plus levator ani muscles (muscle), was 10 times that of testosterone.

Various forms of MENT in human pharmaceutical preparations and devices for contraception and hormone therapy, specifically MENT Ac implant and MENT transdermal gel and patch formulations, are currently under clinical investigation. MENT is absorbed transdermally up to three times the rate of testosterone - 17 methyl testosterone and 17-α methyl testosterone.

MENT will have application in a wide range of indications beyond androgen replacement therapy and contraception, including, without limitation, primary hypogonadism, testicular failure, ASIH, baldness, sarcopenia, loss of bone mass, muscle wasting and cachexia, BPH, prostate cancer and of course, bodybuilding and sports performance enhancement.

Trestolone acetate is the chemical name of active ingredient in MENT. MENT is a registered trademark of Population Council, Inc. in the United States and/or other countries.

Trestolone Acetate 50mg/ml Homebrew

Basic recipe

-1 gram Trestolone Acetate Powder

-16.55 mL Grape Seed Oil (GSO)

-0.6 mL Benzyl Alcohol

-2 mL Benzyl Benzoate

This will achieve a 20 mL solution that has a 50 mg/mL ratio. The 16.55 mL of GSO is calculated based on a 0.85 mL displacement of Trestolone when dissolved. This means that 1 gram of Trestolone Acetate will only take up about 0.85 mL of space. The BA/BB ratio is 3/10.

To make more than 1 gram Trestolone Acetateat a time, simply multiply the amounts by how much you want to do.For example, this guide will demonstrate making 3 grams Trestolone Acetate at one time. The following recipe is used:

-3 grams Trestolone Acetate Powder

-49.65 mL Grape Seed Oil

-1.8 mL Benzyl Alcohol

-6 mL Benzyl Benzoate

Then you will need following items:

-Trestolone Acetate Powder

-Grape Seed Oil

-Benzyl Alcohol

-Benzyl Benzoate

-Empty Vials, sealed and sterile (20mL recommended)

-Large (20mL+) luer lock syringe

-Regular (3mL) luer lock syringe

-A few large gauge luer lock needles (21-18ga recommended)

-Sterile .45u Whatman luer lock syringe filter

-Unsterile .45u Whatman luer lock syringe filter

-A couple small glass jars/beakers to hold your solution

-A large pot/container that can hold hot water and your smaller jar

-Alcohol prep pads

-Paper towels or similar, mainly for cleaning

Trestolone Acetate 50mg/ml cooking step

Make sure your work area is clean. You aren’t going to perform surgery, but you don’t want excessive dirt.

Wipe your empty mixing jars/beakers with an alcohol prep pad, rinse with water, and dry with a paper towel.

Add Trestolone Acetate Powder to one and set to the side. Add some GSO to the other,exceeding the amount needed for your brew. In this case, we need 49.65 mL, so use about 60 mL. Place the GSO jar in the larger container and add hot water to the larger container (NOT THE GSO). This will heat up the GSO for easier filtering.

After heating up, use the larger syringe to draw out some GSO. Screw on the unsterile Whatman filter and start filtering into the jar with the Trestolone Acetate powder.This step may take a few times to finish. For us, we need about 50 mL. The syringe used is 25mL. So, we draw in 25 mL, attach the Whatman, filter, unscrew the Whatman, draw in another 25 mL, reattach the Whatman,and filter the rest. You just need to filter the total needed for the recipe.Using the normal syringe,measure out the appropriate amounts of the Benzyl Alcohol and Benzyl Benzoate. Add to the Trest/GSO solution

At this point, you should have something that looks like mud. This is normal. The Trestolone Acetate is floating around and not much dissolving has happened. Seal off the jar, I use a screw top.

Like we did with the GSO, place the Trest/GSO/BA/BB solution into a bath of hot water to heat it up. You will need to shake up the container to help the dissolving process. Trestolone powder likes to fall to the bottom and clump. Repeat as many times and needed to dissolve most of the Trestolone.

Once most of the Trestolone Acetate dissolves, you’ll have a cloudy dark yellow/orange solution left. You don’t want solid particles floating around. Keep the solution hot.

Grab the large syringe and draw into it enough solution to fill a vial. You may want to pull a little extra on the first vial because the Whatman can hold a full mL itself. Attach the Sterile Whatman filter and slip on a large gauge needle.

Grab a sterile vial, wipe the top with an alcohol pad, and insert a large gauge needle into the top, off center at an angle. This is the venting needle to let out air as you filter in the Trest.

Insert the needle from the syringe into the vial across from the venting needle, at an opposite angle.

Filter.

This stage will take some patience,because the filter will start catching all the bad stuff you don’t want in the solution. There will be a good bit of resistance, just keep at it.Keep the extra solution hot,it makes filtering easier.

How to make order ?

1.Browse our online shop and tell me what product do you want to buy .

2.Contact aimee if there are some problems.

3.Our payment way is Western Union , Money Gram,T/T and Bitcoin.

4.We will send out the parcel in 24 hours after your payment .

5.And then you will get a tracking number .

Welcome to your inquiry !

If you have any questions ,please feel free to contact me .

Manufacturer ---Pharmlab

There are many suppliers in the market ,but look for a reliable supplier is the most important thing. Pharmlab have 98% purity raws with bulk price for distributor partner , and we provide the 100% safe shipping .

  1. USA based delivery to ship , we could guarantee the 100% safe domestic shipping

  2. We have storehouse in France , it was very convient for us to ship to EU ,the customs clearance is 99.99%

  3. Special channel (Only from Pharmlab) ,please send message to us to know more about our process of orders .

https://i.redd.it/29ka96vg66b31.jpg



No comments:

Post a Comment